01 Issaquah · Viking
Range Repair
Sealed-burner ignition, gas valves, griddle plates and oven cavities on Viking Professional and Tuscany ranges.
Crew on site 8:00 am – 8:00 pm, seven days · phone answered 24/7
What people actually say on the phone
- “Front left burner clicks and clicks but never catches”
- “Burner lights, then drops out the second I let go of the knob”
- “Simmer setting still runs a full flame — nothing turns it down”
- “Griddle plate heats on one end and stays cold on the other”
None of these are guesses on our side — they are the sentences that come down the line, and each one maps to a short list of causes we test for.
What this will cost you
One figure is published and it is the same on every job: a $89 service call, credited in full against an approved repair. We do not print repair prices, because a figure quoted before anyone has seen your appliance is a figure we could not honour. What we can tell you now is exactly what moves each one — then you get one firm number, in writing, before any work begins.
| Job | What drives the number | What that covers |
|---|---|---|
| Service call | $89 | Covers the visit, the meter work and a written price before anything is opened. Credited in full against an approved repair. |
| Burner ignition — module or electrode | Which part it turns out to be. An electrode is a fraction of a spark module, and it is the more common failure of the two. | Covers the clicking burner that never catches. |
| Oven igniter or bake element | Part cost by series, and access — a range cavity is reachable from the front; a built-in may have to come out of the cabinet run. | Most common cause of an oven that will not come up to heat. |
| Oven control board or recalibration | A recalibration is labour only and the cheapest outcome here. A board is the dearest, and the price follows the board revision your model takes. | F-codes, runaway temperature, dead display. |
| Door seal, hinge or alignment work | Gasket, hinge set, or both. Panel-ready and integrated doors add time because they come off and go back without marking the cabinetry. | The cheapest work we do, and often the fix for a unit that "will not hold heat". |
The full price board is on the homepage. Anything outside these rows gets the same treatment: diagnosed first, priced second, agreed with you third, and only then opened up. Book online or call (425) 272-6613.
Other Viking work in Issaquah
From the job sheets
What Issaquah says
4.9/ 5· 1,064 reviews
Burner lit, then dropped out the second I let go of the knob. Thermocouple, not the gas valve another company had quoted me for. Twenty minutes, and it has held ever since.
Gareth M. · Olde Town · Apr 2026
Simmer setting ran a full flame no matter where I put the knob. Valve stems had stiffened with age. Rebuilt rather than replaced, which I appreciated, though the kit took a week to arrive.
Petra V. · Olde Town · Oct 2025
Oven side of the range would not come up to heat while the burners were fine. The igniter had gone weak — drawing current, never opening the valve. Replaced on the spot.
Sian R. · Klahanie · Jun 2026
Booking now for Issaquah
Tell us the model
and the symptom.
That is usually enough to know what the part is before anyone gets in the van. $89 service call, credited in full against an approved repair, and a firm price agreed before anything is opened up.
Crew on site 8:00 am – 8:00 pm, seven days. Phone answered 24/7.
